Directions: Clean all surfaces thoroughly. Remove old gaskets and prepare flange surfaces. Dry and remove all oil and grease. Remove cap, puncture inner seal, screw on nozzle and cut to desired size. Apply continuous, uniform 1/16" to 1/8" (1.5 mm to 3 mm) bead around perimeter of one surface. Completely surround all bolt holes. Wait 10 minutes for silicone to "skin over" Reassemble parts. Notes Replace cap after use. Do not over-tighten bolts. Remove excess silicone with dry cloth or alcohol wipe. Silicone dries to touch in 1 hour. Allow 24 hours to fully cure and bond. Leave thickness for gasket when reassembling.